Evinrude Fuel System Bulletin 1220

April 1979 bulletin explaining the revised float chamber gasket for V-4 and V-6 carburetors.

Evinrude Service Bulletin header

FUEL SYSTEM #1220

April, 1979

SUBJECT: CORRECT FLOAT CHAMBER GASKET USAGE

MODEL: ALL V-4 & V-6

The 1978 and later V-4 and V-6 model carburetors use an idle air bleed system which requires a different float chamber gasket that has been used on prior models. The difference in these gaskets is the two triangular shaped holes as shown below. The 1978 V-4 and V-6 parts catalogs list Part No. 314884 Float Chamber Gasket, which is incorrect. There are also some V-4 and V-6 Carburetor Repair Kits (Part No. 383906 for V-4 and 387730 for V-6), which have been assembled with these old gaskets.

If you use these repair kits on '78 and later V-4 and V-6 models, make sure you have the float chamber gasket with the two holes as shown, (Part No. 323784). These new type gaskets can also be used in place of 314884 on '77 and prior V-4 and V-6 models.

Part No. 314884
1977 & prior V-4 & V-6
Earlier float chamber gasket without triangular idle air bleed holes
Part No. 323784
1978 & later V-4 & V-6
Revised float chamber gasket with triangular idle air bleed holes