Evinrude Accessories Service Bulletin #1251 - Handle Cover Kit
Issued April 1980, this bulletin describes a replacement handle cover kit for OMC surface-mount and single-binnacle remote controls with trim switches. It identifies affected 1978-1980 control styles and illustrates how to distinguish the old cover from the revised design.
Subject: Handle Cover Kit, P/N 173742
Models: OMC Parts and Accessories Surface Mount Remote Control with Trim Switch
OMC Parts and Accessories Single Binnacle Mount Remote Control with Trim Switch
OMC has discovered, under certain situations, the trim switch wires in the OMC Parts and Accessories Surface Mount Remote Control with Trim Switch and OMC Parts and Accessories Single Binnacle Remote Control with Trim Switch may become abraded from rubbing on the handle casting.
The handle covers on the following remote controls should be replaced. See Figures 1 thru 4.
Order Handle Cover Kit, P/N 173742, from your Parts Distributor, for all Outboard Remote Controls affected.
The new handle cover can be identified by a smooth area on the outside and the build-up area on the inside with Part Number 123610 molded in the new cover. See Figure 5.
As an aid to you in fulfilling your responsibility to your customers and as an incentive to inspect all units that come into your dealership, OMC will issue a credit voucher plus 10% handling for the cover kit plus allow $5.00 for labor.
Please fill out an Evinrude, Johnson, or OMC Parts & Accessories warranty claim form for each unit reworked and submit to:
ATTENTION: SERVICE DEPARTMENT
3225 Prairie Drive - R.R. #5
Beloit, Wisconsin 53511
Factory part numbers
Handle Cover Kit 173742; old cover 123291; new cover 123610; remote controls 173361, 173575, 173642, 173365, 173579, and 173646.