Evinrude Accessories Service Bulletin #1252

Issued April, 1980, this original Evinrude service bulletin addresses fuel line vacuum tester - special tool p/n 390954 for all v-4 and v-6 outboards using built in fuel systems. The factory document is reproduced below as searchable text.

Evinrude Service Bulletin factory header
ACCESSORIES #1252

April, 1980

Subject: Fuel Line Vacuum Tester - Special Tool P/N 390954

Models: All V-4 And V-6 Outboards Using Built In Fuel Systems

It has come to our attention that damage can be caused to the vacuum gage if installed to engine prior to priming the fuel line.

The instructions supplied with the gauge should be supplemented with the following procedure to prevent damage to this vacuum gauge.

▣ Note

This is a vacuum gauge and can be damaged if pressure is applied with squeeze bulb. Follow instruction in next paragraph.

Start and run engine before installing vacuum tester. Shut engine off after operating temperature is reached. Disconnect fuel line from engine. Connect fuel line vacuum tester between built-in fuel line and engine. Do not squeeze primer bulb after vacuum tester is installed as this will damage gauge. Re-start engine and proceed with test.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Outboard Tachometer / Boat Dash Gauge

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 390954

Search for original or compatible replacement part 390954. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.