Evinrude Service Bulletin #1253: Use of Gasohol
Factory service bulletin issued in 1980. Historical reproduction of the original 1-page technical document.

FUEL SYSTEM #1253
April, 1980
Subject: Use of Gasohol
Models: All 1979 & 1980 Outboards (except V-6)
Outboard Marine Corporation has approved the use of gasohol in the United States in its Evinrude out-
board motors. Gasohol is a fuel generally composed of 10% ethyl alcohol and 90% lead free gasoline.
HOWEVER, THE FOLLOWING PRECAUTIONS MUST BE TAKEN:
As
Gasohol may be used as the primary fuel in all 1979 and 1980 outboard motors with the exception of
V-6 models. However, 1978 and older motors were not designed with gasohol usage in mind. Occa-
sional use is acceptable in the older motors, but frequent use is not recommended.
V-6 motors require leaded fuel with a minimum of 94 Research or 89 Pump Posted octane. Gasohol
should not be used in these models.
Buy fuel as you need it. Gasohol tends to pick up moisture during storage.
Gasohol may dull paint. Avoid spilling it on painted surfaces.
Use Evinrude 50/1 Lubricant and mix thoroughly. If not available, use any other BIA Certified TC-W
oil at 50:1 and mix thoroughly.
Fuel cans should be agitated each day prior to running the motor to ensure good fuel/oil mixture.
Gasoline engines will operate leaner with gasohol. This may cause driveability problems associated
with leaner mixtures.
EVINRUDE MOTORS
Service Department
CR 79-53 Rev. 1 ©OUTBOARD MARINE CORPORATION 1980 ALL RIGHTS RESERVED