Evinrude Service Bulletin #1254: Shifter Clutch Dog P/N 326340

Explains how an incorrectly assembled clutch dog can cause 1980 4.5 and 7.5 HP outboards to jump out of forward gear.

Evinrude Service Bulletin factory letterhead

LOWER UNIT #1254

April, 1980

Subject: Shifter Clutch Dog P/N 326340

Models: 1980 4.5 and 7.5 H.P. Evinrude Outboards

It has been reported that some engines are jumping out of forward gear.

If this condition is encountered, the shifter clutch dog may have been incorrectly assembled due to improper marking on face of clutch dog. Disassembly of gearcase will be required to install clutch dog properly.

“Prop End” may have been stamped on the wrong end. When servicing, install the chamfered end of clutch dog toward the propeller end of propeller shaft. See Figure 1.

The clutch dog is mechanically locked into reverse but it requires a ramp to allow the shifter spring to force the dog out of reverse. If the dog is backwards, it will jump out of forward since the shifter spring can not overcome the torque of the forward gear pushing against the ramped end of the clutch dog.

Factory Figure 1: Shifter Clutch Dog P/N 326340
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 326340

Search for original or compatible replacement part 326340. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.