Back to previous page

SB-1246 - Heavy Duty Motor Mounts

Issued October 1970, this Johnson Service Bulletin describes heavy duty upper and lower motor mounts for 60 H.P. outboards. It specifies parts 384896 and 384897 and explains the tradeoff between high-speed stability and vibration isolation.

Johnson Motors Service Bulletin factory letterhead
SB-#1246
October, 1970
SUBJECT: HEAVY DUTY MOTOR MOUNTS
ON MODELS: 60 H.P.
Heavy duty upper and lower motor mounts are now available for the 60 horsepower motors. These mounts should be used where a greater degree of engine stability must be maintained such as when using the motor at speeds in excess of 40 m.p.h. Engine isolation from the boat will not be as great with the heavy duty mounts; there- fore, an increase in transmitted vibration will be evident.
The heavy duty mounts are available from your Parts Distributor. Order by the following part numbers:
UPPER MOUNT - 384896 (2 Required) LOWER MOUNT - 384897 (2 Required)
JOHNSON MOTORS Doug Cankar Technical Data Coordinator
DC:rm
NOTE: Post on your 60 H.P. Index under the heading "Lower Unit".

Historical service context

The factory bulletin recommends heavy duty mounts where greater stability is needed at speeds above 40 m.p.h. It cautions that these mounts reduce vibration isolation. Upper mount part number 384896 and lower mount part number 384897 each require a quantity of two.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Transom Support Plate & Stainless Mounting Bolt Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 384896

Search for original or compatible replacement part 384896. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.