Johnson Service Bulletin SB-1280 - Starter Lockout Cam Adjustment

Issued January 1972, this bulletin adds a cam-mark alignment step to the 1972 50 H.P. rope-start motor manual-starter adjustment procedure.

Johnson Motors Service Bulletin letterhead
SB-#1280

January, 1972

SUBJECT: Change in Starter Lockout Cam Adjustment Procedure

ON MODEL: 1972, 50 H.P. Rope Start

When servicing the manual starter on 50 H.P. engines, there is one additional adjustment you should make which is not explained in the service manual. On page 9-4 of your service manual there is a note which states:

"If two adjustment screws are disturbed, lockout linkage must be readjusted. Adjust length of link so that starter pinion cannot engage flywheel in forward and reverse gear."

In addition to this operation, you will also have to position the mark on cam 3/32" above the friction drag spring. See illustration.

Please make a note of this additional operation in your service manual.

Original factory illustration showing the cam mark and friction drag spring
JOHNSON MOTORS Doug Cankar Technical Data Coordinator

NOTE: Post on your 50 H.P. index under the heading "Miscellaneous".

DC/sn

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Flywheel Puller Kit & Valve Lapping Compound

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.