Johnson Service Bulletin SB-1307 (January 1973) - Tank Testing Powershift II Motors
Factory safety instructions for tank testing 1973 Johnson outboards with hydraulic assist shifting, including use of spring 304283 to hold the shift lever in gear.

January, 1973
SUBJECT: Tank Testing 1973 Motors with Hydraulic Assist Shift
(Powershift II)

When tank testing the subject motors, it is imperative that the shift lever on the motor be held in the in-gear position by either physical or mechanical means. Failure to hold the motor in gear by physical or mechanical means could result in the motor going into neutral with resultant too high RPM and possible explosion of motor parts.
As shown in the illustration, the shift lever can be held in gear quite easily with spring tension. The spring being used is a 6 H.P. tilt lever stabilizer spring P/N 304283, available from your parts stock or your parts distributor. We are illustrating the springs use on a 65 H.P. motor; however, it will work equally well on 50 H.P. and all V4 models.
Caution should be taken to stay clear of the flywheel and other moving parts when running an engine with the motor cover off. Be careful of loose clothing or hair which may become entangled in the motor.

NOTE: Post on your 50, 65, 85, 115 and 135 H.P. indexes under the heading "Lower Unit".