Johnson Service Bulletin SB-1317: Assuring Full Throttle Advance

Issued May 1973 for 85 through 135 HP V4 outboards, this bulletin describes a spark advance lever interference condition, its corrective modification, and production serial-number changeovers.

Johnson Outboards Service Bulletin factory letterhead

May, 1973

SUBJECT:  Assuring Full Throttle Advance

ON MODELS:  1973, 85 through 135 H.P.

Recently we have had field complaints of some 1973 V4 engines not being able to obtain full throttle advance. This is caused by the boss on the P/N 318561 spark advance lever being too high. The arrows on the photo at the back of this bulletin indicate the original part and one which has been modified.

We would recommend removal and disassembly of the spark advance lever. Since the piece is spring loaded, caution should be exercised.

Remove the spark lever bushing P/N 318560, then file or grind the boss approximately one half of its original height. Enough of the boss (1/4" to 9/32") must be left to allow engagement of the throttle lever spring.

The parts are changed after the following model and serial number.

85ESL73
3857100
115ESL73
3864500
135ESL73
3872600

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator

DL/sn

NOTE:  Post on your 85 thru 135 H.P. index under the heading "Carburetion".

Four original factory photographs of the spark advance lever, with arrows labeling Original and Modified bosses

Historical reference

The factory illustration on page 2 compares the original boss with the modified version. Part numbers 318561 and 318560 are individually linkable above. Production changeover serial numbers are preserved as printed.