Back to previous page

SB-1319 - Potentially Dangerous Steering Kits

Issued June 1973, this Johnson Service Bulletin warns owners and mechanics about aftermarket mechanical steering attachment kits that may interfere with the steering arm when the outboard is fully tilted. It urges a full-tilt clearance check to prevent damage and loss of steering control on 50 through 135 H.P. engines.

Johnson Outboards Service Bulletin factory letterhead
SB-#1319

June, 1973

SUBJECT: Potentially Dangerous Steering Kits

ON MODELS: 50 thru 135 H.P.

Our Engineering Department recently concluded testing of several mechanical steering kits being sold in the aftermarket. All of these kits have one design feature in common - they have a steering cable guide tube mounted on the transom beneath the steering arm. One of the kits we tested was installed on our 3 and 4 cylinder engines mounted on boats with the thickest transom recommended by BIA. We found that these engines couldn't be fully tilted without hitting the steering system. If the engine were to hit an underwater object and tilt up fully, the engine's steering arm would strike the guide tube causing permanent damage to the tube and the steering cable. In one of our tests, permanent damage occurred at only 20 MPH, resulting in a situation where it was not possible to make a port turn.

Because of the potential danger from loss of steering control, we strongly urge that steering attachment kits of this design be thoroughly checked to insure there is adequate clearance between the steering arm and steering components when the engine is in the full tilt position.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

DL/sn
NOTE: Post on your Miscellaneous index under the heading
       Accessories