Johnson Service Bulletin SB-1340 - Service Tips

Issued March 1974, this bulletin provides rewind-starter repair guidance and gearcase shift troubleshooting for 1974 Johnson 9.9 and 15 H.P. outboards.

Johnson Service Bulletin letterhead
SB-#1340
March, 1974 SUBJECT: Service Tips ON MODELS: 1974, 9.9 & 15 H.P. In addition to the service information in your service manuals, the following steps should be taken if you have a repair in the rewind starter or if you receive a customer complaint that the engine jumps out of gear. REWIND STARTER REPAIRS 1. If the starter rope breaks, replace it using a 64" piece of 1/8" diameter rope cut from 100 foot roll 316706. (Early production engines were equipped with a 5/32" diameter rope 71-1/2" long.) 2. If the rewind starter spring breaks, examine the cup and spring guide assembly (P/N 386113) to see if it is identified by a red or blue dye mark or the stamped letter "A". If no dye mark or stamp mark are found, the cup should be replaced. When replacing the spring, do not distort or otherwise damage the outer end of spring during reassembly. Replace the starter rope as explained in "1" above. ENGINE JUMPS OUT OF GEAR If your customer indicates that the engine is jumping out of gear, you must first determine if the condition is occurring in the gearcase or is being caused by misadjustment of the shift lever. Mount the engine in a test tank, disconnect the shift lever detent (on powerhead) and run engine in gear. If engine does not jump out of gear, the condition is caused by a misadjusted shift lever detent. Readjust following the procedure explained on page 6-19 of your service manual. If engine still jumps out of gear, even though shift lever detent is disconnected, the condition is in the gearcase. Remove the gearcase and check the position of the lower shift rod height as explained on page 6-18 of your service manual. If this adjustment is to specifications, the condition is occurring within the gearcase.
(over)
PAGE 2SERVICE BULLETIN  SB-#1340
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Factory photograph of shifter assembly showing welding flash and bent shifter
Disassemble gearcase and inspect outer diameter of hub of forward gear. If any wear marks are seen, it is an indication that the shifter lever is rubbing. Inspect the shifter lever for welding flash at points indicated. If any is found, file it off. Check to make sure shifter assembly is not bent or twisted to one side. If it is, straighten or replace it as required. Finally, inspect shifter's freedom of movement at the riveted joint. If this joint is not free, replace the assembly.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/sn NOTE: Post on your 9.9 and 15 H.P. indexes under the heading "Miscellaneous" and "Lower Unit". FOOTNOTE: The minimum acceptable test propeller RPM on the 9.9 outboard is 5400 and on the 15 H.P. outboard is 6200. Please post this information in your 9.9 and 15 H.P. service manuals in the specification section under tank test with test wheel RPM.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter & Marine Electrical Connector Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 386113

Search for original or compatible replacement part 386113. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.