Johnson Service Bulletin SB-1345 (May 1974) - Rerouting of Ignition Coil Ground Lead

Johnson instructed mechanics servicing 2, 4, and 6 HP outboards to inspect the ignition coil ground lead whenever the flywheel is removed. The bulletin illustrates the original routing and the corrected downward position.

Johnson Service Bulletin letterhead
SB-#1345

May, 1974

SUBJECT: Rerouting of Ignition Coil Ground Lead

ON MODELS: 2, 4, 6 H.P.

Whenever the flywheel is removed from a 2, 4, or 6 H.P. engine, the ignition coil ground lead routing should be checked. If you find the ground lead going over the top of the coil as in figure 1, bend it down as shown in figure 2.

Figure 1: Ground lead routed over top of ignition coil
FIGURE 1
Figure 2: Ground lead bent down below top of ignition coil
FIGURE 2
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator

DJL/sn

NOTE: Post on your 2, 4, and 6 H.P. indexes under the heading "IGNITION".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Flywheel Puller Kit & Valve Lapping Compound

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.