Back to previous page

SB-1346 - Lubrication of Tilt Tube

Issued May 1974, this Johnson Service Bulletin explains the proper lubrication and regreasing intervals for 1973-74 50 through 135 H.P. outboards fitted with thru-the-pivot steering systems. The original factory instructions are reproduced as searchable text below.

Johnson Outboards Service Bulletin factory letterhead
SB-#1346

May, 1974

SUBJECT: Lubrication of Tilt Tube

ON MODELS: All 1973-74, 50 thru 135 H.P. Engines with Thru-the-
Pivot Steering Systems

NOTE

The installation instructions supplied with OMC Rotomatic steering systems advise you to grease the end of the steering cable prior to installing the cable into the engine tilt tube. Greasing the cable serves the dual purpose of protecting both the steering cable and the I.D. of the tilt tube. If a steering system other than OMC is used this greasing operation should still be performed.

Once the engine is put into operation, periodic regreasing is required. In fresh water, regreasing should be done annually. In salt water regreasing may be required as often as every 90 days. In addition, regreasing should also be done if the unit is being put into storage for 30 days or more.

Always use OMC Sea Lube Anti-Corrosion lubricant for this service operation.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

DJL/sn

NOTE: Post on your 50 thru 135 H.P. indexes under the heading
"Lower Unit".