SB-1357 - Flywheel Key Installation

Issued in September 1974, this Johnson Service Bulletin explains correct flywheel key orientation on 1974 75, 9.9 and 15 H.P. outboards and corrects instructions in the 9.9 and 15 H.P. service manuals.

Johnson Outboards Service Bulletin letterhead
SB-#1357
September, 1974
SUBJECT: Flywheel Key Installation
ON MODELS: 1974 - 75, 9.9 & 15 H.P.
When inserting the flywheel key into the crankshaft keyway on 9.9 & 15 H.P. engines, make sure the single upset mark on the side of key is facing down and the top surface of the key is parallel to the crankshaft taper (see illustration). Correct installation is important since the key also drives the ignition cam and, if there is not enough bearing area on the driving surface, the cam's keyway will become worn resulting in erratic spark timing.
The 1974, 9.9 & 15 H.P. service manuals are incorrect in stating that the key should be installed parallel to the crankshaft centerline (page 4-10 and figure 4-33 on page 4-11). Please note this correction in your manuals.
Factory illustration showing flywheel key installed parallel to crankshaft taper, with upset mark facing down
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/sn
NOTE: Post on your 9.9 & 15 H.P. index under the heading "Powerhead".