Johnson Service Bulletin SB-1377 (February 1975) - New Impeller Housings

Johnson announced plastic impeller housings with stainless steel liners for 50 through 135 HP outboards, warning that running without cooling water can permanently damage the housing. Includes a 50 HP water pump kit parts list and exploded illustration.

Johnson Service Bulletin factory letterhead
SB-#1377
February, 1975

SUBJECT:   New Impeller Housings

ON MODELS:  50 thru 135 H.P.

We are in the process of switching from aluminum impeller housings to plastic housing with stainless steel liners. The stainless steel liners provide improved housing durability and lower cost repair parts when service becomes necessary.

Engines equipped with plastic impeller housings should never be run out of water, not even for a few seconds. The frictional heat resulting from a dry impeller rubbing on the liner can cause permanent damage to the housing. A caution transfer is on the lower motor cover near the fuel connector to remind you of this. Make sure the transfer remains on the engine and that the customer is familiar with it.

You will be seeing the plastic impeller housings on 50 H.P. engines first. As you can see from the illustration, they are similar in appearance and construction to the chrome pump kits we have offered for several years.

REF.
NO.
PART
NO.
NAME OF PARTQTY.
PER ASSY.
*387216WATER PUMP KIT - 50 H.P.1
1303059"O" RING, Drive shaft1
2320776PLATE, Liner1
3320775LINER, Impeller housing1
4315788SEAL, Impeller housing1
5315837GROMMET, Water tube1
6320777TRANSFER, Caution1
7316357SCREW, Imp. hsg., short2
8320981PLATE, Impeller housing1
9377230IMPELLER ASSEMBLY1
10384087IMPELLER HOUSING ASSY1
11315748GROMMET, Exh. to housing1
12316658SCREW, Imp. hsg., long2
*308928KEY, Impeller1
* NOT SHOWN
Factory exploded diagram of 50 HP water pump and impeller housing components
JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator