SB-1379 - Correct Installation of #319895 Clutch Dog Shifter

Issued April 1975, this Johnson Service Bulletin explains the correct orientation of clutch dog shifter part #319895 on 1975 50 H.P. and short 75 H.P. small-gearcase outboards. Incorrect installation can damage the gearcase.

Johnson Outboards Service Bulletin letterhead
SB-#1379
April, 1975
SUBJECT: Correct Installation of #319895 Clutch Dog Shifter
ON MODELS: 1975 50 H.P. and Short 75 H.P. Small Gearcase
Recently, we have inspected several of the #319895 clutch dog shifters which have failed on 50ES75, 50ESL75 or the 75ESR75 small gearcase models. In every case the clutch dog shifter has been installed backwards on the prop shaft. The results are excessive loads being applied to the tangs of the clutch dog.
The tangs become rounded or break off often causing severe damage to the gearcase components due to the pieces getting into the bearings or between the teeth of the gears. Since the clutch dog shifter is stamped "prop end" as shown in the illustration below, the mechanic should not have any diffi- culty in making correct installation.
Factory photograph showing PROP END marking on clutch dog shifter part 319895
JOHNSON OUTBOARDS
D. J. Leinonen Technical Data Coordinator
NOTE: Post on your 50 and 75 H.P. indexes under the heading "Lower Unit".
SPECIAL NOTE: Post SB#1380 on your 50 thru 135 H.P. indexes under heading "Electrical".