Back to previous page

SB-1382 - Water in Power Packs

Issued May 1975, this Johnson Service Bulletin explains how moisture can cause erratic ignition power-pack operation on 1973-1975 50 through 135 H.P. outboards. It provides inspection, drying, retesting, and sealing instructions.

Johnson Outboards Service Bulletin factory letterhead
SB-#1382

May, 1975

SUBJECT: Water in Power Packs

ON MODELS: 1973 thru 1975 50 thru 135 H.P.

Inspection of power packs returned to us on warranty recall has shown that many of the packs are good. We have found signs of water in many of them which could have led to temporary grounding of the components resulting in an erratic or inoperative condition.

When an OMC power pack tests bad be sure that there isn't any water between cover and interior terminals. When water is found dry and clean the pack and terminals and retest pack.

We believe that the water is entering the pack by dripping through the holes around the screws in the tilt handle at the back of the motor cover. This usually happens when the engine is stored outside in a tilted position.

When this condition is experienced seal the holes at the tilt handle of the motor cover with OMC Sea Caulk, OMC Adhesive M or other effective marine sealer.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

DJL/kr

NOTE: Post on your 50 thru 135 H.P. indexes under the heading
"Ignition".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.