SB-1389 - Improving Reverse Thrust on Displacement Hulls

Issued in August 1975, this Johnson Service Bulletin describes an exhaust relief modification for 1974-1976 9.9 and 15 H.P. motors used on displacement hulls, with important cautions about high-thrust kits and hole size.

Johnson Service Bulletin factory letterhead
SB-#1389
August, 1975
SUBJECT: Improving reverse thrust on Displacement hulls
ON MODELS: 9.9 & 15 h.p. 1974 thru 1976

Due to the increasing popularity of Sailboats and houseboats and the use of 9.9 or 15 h.p. engines on them we have received many requests for information on how to improve the reverse thrust on these non-planing displacement hulls. Usually the complaint is that the boat is difficult to stop or it won't back out of a slip easily although it runs fine in forward gear.

This modification should not be made on small planing type boats since it will cause excessive exhaust noise.

The following procedure will improve the reverse thrust capability of these engines by reducing the amount of exhaust gas that flows through the propeller hub while the unit is in reverse gear. Remove gearcase (and extension if long shaft). Center punch two holes in rear webb of gearcase. Drill two 5/16" holes as shown in the gearcase on the right of figure 1. Center punch the exhaust housing in the same manner and drill two 5/16" holes in the rear webb as on the right hand casting of figure 2.

Figure 1: gearcase exhaust relief hole locationsFigure 2: exhaust housing relief hole locations
PAGE 2 SERVICE BULLETIN #1389 JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

Do not drill holes larger than 5/16" since larger holes could allow the reverse thrust to build up to the point of disengaging the reverse locking lever and the engine would tilt out of the water. Although the location of the holes is not critical to the relief of the exhaust be sure that there is some space between them and that the holes do not break through the mating surface between the gearcase and exhaust housing. Do not modify any long shaft engine that has the P/N 173207 high thrust kit installed. This kit can be identified by the slots cut into the exhaust passage of the 5 inch extension.

While gearcase is removed modify water pump relief hole as recommended in SB #1387.

Be sure to select a propeller that will allow the engine to operate in the recommended RPM range at full throttle in forward gear.

JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
NOTE: Post on your 9.9 & 15 h.p. Index under heading "Lower unit".