Johnson Service Bulletin SB-1390 - Lifting Engine and Removing Engine From Shipping Carton

Issued September 1975, this factory bulletin describes use of OMC lifting eye 321537 and unpacking procedures for 1976 Johnson V-6 outboards.

Johnson Service Bulletin factory letterhead
SB-#1390
September, 1975 SUBJECT: Lifting Engine and Removing Engine From Shipping Carton ON MODELS: 1976 V-6 I. LIFTING ENGINE ▣ NOTE Unlike other large horsepower models in our line, the V-6 does not come equipped with a lifting bracket. To hoist this engine, we have developed a lifting eye (P/N 321537) which is used with your OMC flywheel puller. The lifting eye should be attached as shown. See figure 1. Be sure that the flat shoulder of the three screws are tightened to the flywheel. Insert the lifting eye and tighten it firmly to the center taper of the crankshaft. Do not overtorque. You will find that by placing the lift point above the crankshaft center line, the engine will hang straighter and will be easier to install or remove from the typical boat transom. (The lifting eye is an OMC Special Tool available through your OMC parts supplier.) II. REMOVING ENGINE FROM SHIPPING CARTON Because of the height and weight of the V-6, removing the engine from the shipping carton may prove difficult. One way to remove these engines with a minimum of effort or chance of damage is as follows: 1. Lay the carton on its side. See figure 2. 2. Slit the tape on lower end of box and pull flaps apart. 3. Cut the banding strap from the upper end of box and remove cap. 4. Slit the box from end to end. See figure 3. 5. Remove the propeller, fuel tank and remote control. 6. Remove the supporting corrugated cardboard from around powerhead and gearcase. 7. Remove motor cover and attach lifting eye (P/N 321537) to flywheel (see figure 1.) Hoist engine to vertical position. See figure 4. (See figures on other side)
PAGE 2SERVICE BULLETIN SB-#1390
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085
Factory figures 1 through 4: lifting eye, shipping carton, opened carton, and engine hoist
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/kr NOTE: Post on your V-6 index under heading “Miscellaneous”.

Factory references

OMC lifting eye P/N 321537 is identified as a special tool used with the OMC flywheel puller. The four factory photographs illustrate the procedure.

1970-1980 Johnson Service Bulletin Index

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Flywheel Puller Kit & Valve Lapping Compound

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 321537

Search for original or compatible replacement part 321537. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.