SB-#1407
February, 1976
SUBJECT: New Plastic Bodied Water Pump Housing
ON MODELS: 1974 - 1976 9.9 and 15 H.P.
We have received a number of complaints of failure of the stain-
less steel liner on 9.9 and 15 h.p. water pumps used in salt water
areas. The collapse of the liner is due to salt water corrosion
taking place between the liner and pump body.
When 9.9 or 15 h.p. engines used in salt water areas come in for
service, inspect the pump as a normal service procedure. The
aluminum housings on these engines should be replaced with part
number 388139 plastic pump housing and cup assembly.
These engines can also be serviced using the pump kit 387610 which
contains all pump parts.
NOTE
The recommended torque for pump housing screws is
5-7 foot pounds (7-9Nm). Exceeding this torque
may damage the housing.
All 1976 9.9 and 15 h.p. outboards beginning with the following
serial numbers have the plastic pump housings.
10R76 4384823 15R76 4410014
10RL76 4402268 15RL76 4424688
10E76 4403567 15E76 4426826
10EL76 4405799 15EL76 4429682
NOTE
When the engine is returned to the customer be sure to stress that
the engine should not be run out of water even for a few seconds
since this will result in rapid heat build up and distortion to
the plastic pump.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your 9.9 and 15 h.p. index under heading "Lower Unit."
DJL/kr