Johnson Service Bulletin SB-1408 (February 1976) - Possible Interference in Steering System
Johnson's February 1976 safety bulletin warns about steering connector interference on 1976 35 HP outboards equipped with Thru-The-Pivot steering, and explains the clearance inspection required for non-OMC connector kits.

February, 1976
SUBJECT: Possible Interference in Steering System
ON MODELS: 1976 35 H.P. With Thru-The-Pivot Steering
SAFETY WARNINGIt has come to our attention that some steering connector kits
for 35 h.p. outboards can have an interference condition between
the stern brackets and the head of the steering connector bolt.
See illustration. In an extremely tight turn, it is possible
to apply enough force to the steering wheel to unknowingly
force the head of the screw past the end of the stern bracket.
If this occurs, the operator will not be able to readily return
the engine to center creating a potentially dangerous situation.
If you install a steering connector kit other than OMC, check
for adequate clearance between the screw head and both stern
brackets with the thrust rod in the rearmost hole. This check
should be made at every installation since clearance will vary
depending on installation technique. If interference is found,
the outside corners of the stern brackets should be filed to
provide adequate clearance.

D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your 35 h.p. index under heading "Miscellaneous".