Back to previous page

SB-1409 Rev. 1 - Change in Wiring Location

Issued February 1976, this revised Johnson Service Bulletin explains how to relocate the high-tension ignition lead clamp and secure the leads with tie strap P/N 320107 on 1969 through 1976 4 H.P. outboards. The original instructions are searchable, with all three factory diagrams retained.

Johnson Outboards Service Bulletin factory letterhead
SB-#1409 Rev. 1

February, 1976

SUBJECT: Change in Wiring Location

ON MODELS: 1969 Through 1976 4 H.P.

We recently changed the location of the high tension lead clamp on 4 H.P. Outboards from that shown in Figure 1 to the location shown in Figure 2. In addition, we are securing the high tension leads to the fuel pump mounting boss using a P/N 320107 Tie Strap. See Figure 3. These changes reduce the possibility of the high tension leads getting caught on the motor cover during cover removal.

We recommend you perform this modification whenever you have a 4 H.P. engine in for service.

Figure 1: Old high tension lead clamp location
Figure 1
Figure 2: New high tension lead clamp location
Figure 2
Figure 3: Tie strap securing high tension leads at fuel pump mounting boss
Figure 3
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 4 H.P. index under heading "Ignition".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester & Digital Multimeter

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 320107

Search for original or compatible replacement part 320107. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.