SB-1426 - Installing Plastic Converging Rings on Aluminum Thru Hub Propellers

Issued in July 1976, this Johnson service bulletin describes the handling and arbor-press installation of Lexan plastic converging rings on aluminum thru-hub propellers.

Johnson Service Bulletin factory letterhead
SB-#1426
July, 1976
SUBJECT: Installing Plastic Converging Rings on Aluminum Thru Hub Propellers
ON MODELS 50 H.P. 3 Cylinder, and V-4 Outboards
The lexan plastic converging rings used on some Johnson 2, 3 cylinder and V-4 aluminum thru hub propellers are corrosion proof, tough and light weight, but do require service procedures slightly different from converging rings made of other materials.
These plastic converging rings will be damaged if exposed to many strong chemicals. They should not be painted with lacquer paint or washed with lacquer thinner. They should not be washed with acetone, trichlorethylene, methylene chloride, or any of the common solvents, fuels or parts cleaners.
If a propeller with a lexan plastic converging ring is to be painted with a lacquer paint, the converging ring must be removed first, the converging ring groove masked, the propeller painted, and the converging ring reinstalled after one hour.
All plastic rings are easily installed with an arbor press and pressing plate. See Figure 1 on back of page. Press only until the ring snaps into the groove.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator
DJL/kr
NOTE: Post on your Miscellaneous index under heading "Accessories".
(over)
Original factory photograph showing the propeller and arbor press installation of the converging ring

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench & Marine Spline / Triple-Guard Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.