Johnson Service Bulletin SB-1431 - Crankshaft Appearance

September 1976 factory explanation of shot-peened crankshaft surface finishes on 1970-1973 Johnson 40 H.P. outboards.

Johnson Service Bulletin letterhead
SB-#1431

September, 1976

SUBJECT: Crankshaft Appearance

ON MODELS: 40 H.P.

In 1972 a shot peening process was incorporated in the manufacturing of the #311356 crankshaft, used on 1970 - 1973 40 H.P. outboards. The treatment, used on the upper crankshaft throw, primarily in the upper journal-to-upper-thrust-face radius, improves the fatigue life of the crankshaft for longer service.

Due to routing changes in the manufacturing process there are crankshafts with several appearance differences.

1. Crankshafts that were shot peened last may have a dull finish over the entire upper journal and upper thrust face. See figure 1.

2. Crankshafts shot peened last, with a mask over the journal lower half, have a dull finish only on the journal upper half and upper thrust face. See figure 2.

3. Crankshafts with a final lapping operation after shot peening have a dull finish only in the upper radius and upper thrust surface. See figure 3.

All three varieties of the crankshaft have the essential shot peening treatment for improved fatigue life whether apparent, figures 1 and 2, or not so apparent, figure 3.

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator

DJL/kr

NOTE: Post on your 40 h.p. index under heading "Powerhead".

(over)

Original sideways factory page showing crankshaft figures 1, 2, and 3, with dull finish and polished areas

Factory illustration

The three figures on page 2 illustrate acceptable differences in crankshaft appearance after shot peening. The original illustration orientation is preserved.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

OMC/Evinrude OEM P/N 311356

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 311356

Search for original or compatible replacement part 311356. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.