Johnson Service Bulletin SB-1455 (March 1978) - V-6 Pinion Bearing Torque
Johnson's 1978 service instructions for correct pinion bearing installation and pinion gear nut torque on 1976-1978 V6 gearcases, including the consequences of overtorquing and undertorquing.

SB 1455
March 1978
SUBJECT: V-6 PINION BEARING & PINION GEAR NUT TORQUE SPECIFICATION
MODEL: 1976 - 1978
Incorrect installation of the pinion bearing in the 1976-1978 V-6 gearcase drastically reduces the life of the bearing. The bearing is tapered so that when installed correctly its shape compensates for stresses in the gearcase and allows full roller contact. When a gearcase is disassembled the pinion bearing should be checked to insure that it has been installed with the “lettering” up. Check for spalling on the corners of the rollers and replace the bearing if necessary.
The correct torque on the pinion gear nut in the lower gearcase is 60 - 65 ft. lbs. (85-90 Nm). This torque is very important in maintaining long life to the pinion gear.
If the nut is over torqued, too much stress is placed on the pinion gear which may shorten the life of the pinion gear.
If less than 60 ft. lbs. (85 Nm) of torque is applied, a condition known as “fretting” (i.e., metal transfer between the gear and taper, caused by the gear moving on the taper) will shorten the life of the component parts.
Always apply the correct torque to this nut when performing service to the gearcase.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
D.J. Leinonen
Technical Data Coordinator
NOTE: Post on V-6 index under heading “LOWER UNIT”.
CR78-24
Related subject: V6 lower-unit service and pinion bearing installation. Refer to the applicable factory service manual for the complete gearcase procedure.