SB-1457 - 1978 OMC Accessory Remote Control Replacement Program

Issued in April 1978, this Johnson Service Bulletin announces a safety-related field replacement program for selected 1978 OMC accessory remote controls used with V-6 outboards. It lists affected control assemblies and the dealer replacement and reimbursement procedures.

Johnson Service Bulletin factory letterhead
SB-1457
April, 1978
Safety warning triangleSAFETY WARNING
SUBJECT:     FIELD REPLACEMENT PROGRAM FOR CERTAIN
              1978 OMC ACCESSORY REMOTE CONTROLS
DEAR JOHNSON DEALER:

Johnson Outboards has instituted a field replacement program for certain 1978 OMC Accessory Remote Controls which are used in conjunction with a V-6 Johnson outboard motor. We have learned there is the possibility that these controls, when used in conjunction with a V-6 engine, may become difficult to operate and may eventually lock up. This could result in the operator being unable to reduce the speed of his boat or to shift the outboard motor into neutral.

The following OMC Accessory Remote Controls are affected:

173360   Side Mount, Single Lever
173361   Side Mount, Single Lever with Trim Switch
173364   Binnacle Mount, Single Lever
173365   Binnacle Mount, Single Lever with Trim Switch
173366   Binnacle Mount, Dual Lever

All registered owners of V-6 outboard motors will receive notification to contact the Johnson dealer of their choice for replacement of affected remote controls. The notification letter (see enclosed), along with a special claim form, will be mailed one week from the date of this letter.

When the above-mentioned claim form is presented to you by a registered owner, please confirm that the rig in question does incorporate a V-6 Johnson motor and an accessory control as illustrated in the owners notification letter. There is no need to replace the Johnson Command Center control that was shipped with the motor.

After confirming the need for replacement, mail the service department copy of the claim to us and retain the dealer copy for your files. Return the customer copy to the customer and make an appointment to remove the old control and replace it with a new control which will be shipped to you upon our receipt of the claim form. Allow two weeks for us to get the part to you. You will be allowed one hour labor for effecting the change which must be done at no cost to the customer.

PAGE 2 SERVICE BULLETIN
JOHNSON OUTBOARDS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60085

If you have any of the remote controls listed above in stock, you may attach them to a V-6 outboard motor providing the letter “H” or “L” appears below the part number on the carton as well as on the remote control housing at the point where the cables exit the housing. The letter code signifies the controls have been modified and are suitable for use with a V-6 outboard motor as well as all other model outboards. Controls which have not been modified may be used for all applications other than with V-6 motors.

Remote controls removed from customers boats should be returned freight prepaid, to the Johnson Service Department. A $2 freight allowance will be included with your one hour labor reimbursement.

Cordially,
Service Manager
Encl./Customer letter
Note: Post on miscellaneous index under heading “Accessories”.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Control Cable Connectors & Marine Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 173360

Search for original or compatible replacement part 173360. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.