Back to previous page

SB-1460 - Removal of Driveshaft in V4 & V6 Gearcase

Issued April 1978, this Johnson Service Bulletin explains why some V4 and V6 driveshafts fit tightly in the gearcase and identifies the redesigned driveshaft removal tool, OMC P/N 389929. The complete factory notice is reproduced as searchable text.

Johnson Service Bulletin factory letterhead
SB-1460

April, 1978

SUBJECT: REMOVAL OF DRIVESHAFT IN V-4 & V-6 GEARCASE

Some driveshafts in V-4 and V-6 Outboards may prove very difficult to remove while others can be lifted out with very little effort.

Even though the taper on the driveshaft is not intended to be a locking taper or to provide an interference fit, the tolerances are quite close and may produce the tightness sometimes encountered. This condition can be considered normal and in either event, loose fit or tight fit, does not materially affect the service life of the gearcase.

A redesigned Driveshaft Remover Special Tool P/N 389929 will soon be available from your distributor for removal of the tight fitting driveshafts.

JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator

CR78-11

NOTE: Post on V-4 & V-6 indexes under heading “Lower Unit”.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 389929

Search for original or compatible replacement part 389929. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.