Back to previous page

SB-1464 - 100:1 Two Cycle Lubricants

Issued May 1978, this Johnson Service Bulletin addresses claims that 100:1 two-cycle oils were B.I.A.-certified. Johnson explains the then-current 50:1 B.I.A.-TC-W certification and its warranty position. The original factory notice is reproduced below as searchable text.

Johnson Service Bulletin factory letterhead
SB-1464

MAY 1978

SUBJECT: 100:1 TWO CYCLE LUBRICANTS

We have been informed that some marketers/refiners of two cycle lubricants are promoting their products claiming their lubricant has been certified by the B.I.A. for 100:1 fuel-oil ratio.

For your information, the B.I.A. does not certify two cycle, water cooled lubricants for 100:1 ratios.

The present B.I.A.-TC-W certification is for 50:1 ratio.

The following statement appeared in the B.I.A. Monday Morning Report of 9/5/77.

“TASK FORCE ABANDONS 100:1 OIL TESTS”

The B.I.A. Oil Test Task Force meeting in Chicago late last month agreed to a formal withdrawal of the tentative oil test procedures for 2-cycle oil at a 100:1 gas-to-oil ratio.

“We’ve seen several instances of oil companies crowing that their products have been BIA-Certified for use at 100:1. Such claims aren’t true. The test procedures for 100:1 oil were only tentative, and BIA has never certified a TWC/100 oil. Until the problems with the oils and tests are ironed out, there won’t be any such thing,” commented BIA man Don Reed.

Task force members pointed out that the tentative tests were not sufficiently definitive. Some lubricants tested showed considerable deficiencies at the 100:1 ratio; lubrication of anti-friction bearings often proved insufficient; and the accelerated lubricity test didn’t always separate the effective oil from the ineffective. In addition, engine manufacturers represented at the meeting noted that there was a problem in finding a definitive test for rust prevention. No known lubricant does the job at 100:1, they pointed out.”

Therefore, until such time as the B.I.A. Oil Test Task Force establishes a certification procedure for 100:1 fuel-oil ratio, and certifies specific lubricants, any warranty claims on Johnson Outboards resulting from the use of lubricants at 100:1 ratio will not be honored.

The only approved lubricant for use in Johnson outboard motors is Johnson 50:1 lubricant or other lubricants which carry the B.I.A.-TC-W Certification.

CR78-35
Johnson Outboards

D. J. Leinonen
Technical Data Coordinator

NOTE: Post on 2 thru V-6 indexes under heading “Miscellaneous.”