SB-1475 - Choke Clevis Wear and Loosening Due to Vibration
Issued in July 1978, this Johnson Service Bulletin describes how to prevent wear and loosening of the choke clevis on V-4 outboards through 1978 using thread primer and locking compound.
SB 1475
July, 1978
SUBJECT: CHOKE CLEVIS WEAR AND LOOSENING DUE TO VIBRATION
MODELS: V-4's THRU 1978
You may find that after use some V-4 motors may develop wear at the threaded connection between the choke clevis and the choke solenoid plunger.
To reduce the chance of this condition recurring upon reassembly of a new plastic choke clevis, clean the mating screw threads with OMC Locquic Primer P/N 384884, or equivalent. After final adjustment, as outlined in your Service Manual, apply a small amount of OMC Ultralok P/N 388517, or equivalent, to the top end of the clevis where the solenoid plunger screws into the clevis.
It is recommended that this procedure also be followed with new motors as a part of your pre-delivery servicing.
Johnson Outboards
D.J. Leinonen
Technical Data Coordinator
NOTE: Post on 85 thru 140 h.p. indexes under heading “Carburetion.”
CR78-47