Johnson Service Bulletin SB-1477 (August 1978) - Integral Tilt & Trim Check Valves

Johnson explained how to reassemble integral tilt and trim check valves that separate when removed from the manifold, and clarified when warranty credit would be allowed.

Johnson Motors Service Bulletin letterhead
SB-1477

August, 1978

SUBJECT: SEPARATION OF “INTEGRAL” TILT & TRIM CHECK VALVES

Occasionally check valves P/N 387376 or 387517 will fall apart when they are removed from the manifold. These valves are not damaged and should be reassembled by pressing parts back together in the order shown in the accompanying photograph.

It is recommended that parts be pressed together using a vise equipped with soft jaws or a small arbor press.

NO WARRANTY CREDIT WILL BE GIVEN FOR
VALVES THAT HAVE SEPARATED WHERE NO
OTHER DEFECTIVE CONDITION EXISTS.

Factory photograph of separated check valve components, arranged for reassembly

Johnson Outboards

D.J. Leinonen
Technical Data Coordinator

CR78-46

Note: Post on 85 through V-6 Indexes under heading “Lower Unit”.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 387376

Search for original or compatible replacement part 387376. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.