Back to previous page

SB-1478 - Hydraulic Tilt and Trim Check Valve Corrosion

Issued August 1978, this Johnson Service Bulletin describes check valve corrosion on Prestolite power tilt and trim systems, repair kit 173569, and preventive sealing procedures.

Johnson Service Bulletin factory letterhead
SB-1478

August, 1978

SUBJECT: HYDRAULIC TILT AND TRIM CHECK VALVE
CORROSION AND REPAIR KIT P/N 173569

It has been reported that under certain salt water conditions the check valves in hydraulic pump assembly P/N 173857 become corroded and leak hydraulic oil. These valves are installed on units equipped with the non-integral “PRESTOLITE” power tilt and trim unit. (See Figure 1 for identification.) A valve kit is now available, P/N 173569, that consists of the following parts:

2 - check valves with o-rings
2 - check valve retaining rings
1 - shuttle valve o-ring
1 - instructions for repair

Before ordering the above repair kit, scrape off any corrosion built up around the valves and retaining ring (Figure 1), and inspect the area of each retaining ring groove and if the groove itself has enlarged from corrosion, then the pump assembly P/N 173569 will have to be replaced. If only the valves are eaten away by corrosion, then apply a liberal coat of OMC Anti-Corrosion Lube (or equivalent) to prevent further damage until the repair kit can be installed.

Figure 1: front and rear check valve locations on Prestolite tilt and trim unit

If you find a unit whose valves show very light corrosion but no leakage, perform the following preventative maintenance:

1.

Carefully scrape corrosion off of both valves and retaining ring areas and spray OMC Locquic Primer (or equivalent) on the area and allow to dry.

2.

Completely fill the cavity formed by the valves with RTV Adhesive-Sealant, OMC P/N 263753 (Figure 2), and allow to dry before subjecting the unit to water.

Figure 2: check valve cavity filled with RTV adhesive sealant

NOTE: THIS REPAIR KIT MAY ALSO BE USED TO REPAIR PUMP P/N 173857 UNDER CERTAIN CONDITIONS WHERE TRIM OR TILT LEAKDOWN OCCURS. FOLLOW THE INSTRUCTIONS PROVIDED IN THE KIT.

Johnson Outboards

D. J. Leinonen
Technical Data Coordinator

CR78-55

Note: Post on 85 through 135 indexes under heading “Lower Unit”.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

NMMA TC-W3 2-Stroke Marine Outboard Oil & Oil Mixing Ratio Bottle

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 173569

Search for original or compatible replacement part 173569. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.