Back to previous page

SB-1482 - New Hot Horn

Issued October 1978, this two-page Johnson Service Bulletin introduces the corrosion-resistant plastic hot horn and explains how to prevent the purple ignition lead from shorting against the remote control housing.

Johnson Service Bulletin factory letterhead
SB-1482
OCTOBER 1978

SUBJECT: NEW HOT HORN

MODELS: 1973 THROUGH 1978 STANDARD REMOTE CONTROL

Factory photograph comparing old metal hot horn 279336 and new plastic hot horn 388910

The plastic construction should make this horn less vulnerable to corrosion in a salt water environment and extend its useful life.

Due to printing schedules, the part number for the new horn does not appear in any 1978 parts books. Since it does offer an improvement in overall performance, it is desirable that this new horn be used whenever replacement is required.

The new horn will replace the old metal horn and associated parts in all remote control assemblies from 1973 to the present 1978 model.

Please mark all your parts books for 1973 through 1978 with remote controls to indicate the following changes:

279336 use 388910
317930 not required with 388910
323334 not required with 388910
Johnson Outboards

D. J. Leinonen
Technical Data Coordinator

NOTE: Post on 55 thru V-6 indexes under heading “Electrical”.

HOT HORN LEAD SHORTING TO REMOTE CONTROL
TRIM & TILT ENGINES

We have heard of several cases of the hot horn, where the purple lead from the key switch has shorted against the remote control box (casting). Most cases have occurred on engines that have the trim gauge lead or accessory tachometer lead attached to the purple wire using adapter P/N 319984. This may short circuit the 20 amp fuse in the engine wiring harness.

To eliminate this condition, change the original position of the purple wire to the terminal to tan wire terminal and put the tan wire on the terminal where the purple wire was previously attached. This procedure must be followed when new hot horn P/N 388910 is used to replace the old horn P/N 279336.

Two factory remote-control wiring diagrams showing purple lead, tan lead, dual-terminal adapter 319984, and horn assembly

Factory bulletin references: Hot horn 388910 replaces 279336. Adapter 319984 is referenced in the remote-control wiring instructions.