SB-1489 - Wiper Nut P/N 322376

Issued in January 1979, this Johnson Service Bulletin recommends a corrosion-protective wiper nut for outboards equipped with tilt-tube steering, particularly in saltwater service.

Johnson Outboards Service Bulletin factory letterhead
SB-1489
January, 1979
SUBJECT: WIPER NUT P/N 322376
MODELS: ALL OUTBOARDS WITH TILT TUBE STEERING
We strongly recommend the use of wiper nut P/N 322376 in place of the locknut supplied with motor on tilt tube to give additional corrosion protection to the tilt tube.
This is an essential requirement in salt water areas as this special nut holds grease in tilt tube and spreads a film of grease on steering shaft each time the steering cable is moved.
When installing nut, lubricate the inside of steering tube and pack wiper nut with OMC Anti-Corrosion lube or equivalent.
Factory photograph of wiper nut installed on steering tilt tube
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
Note: Post on miscellaneous index under heading “Engine Miscellaneous.”
CR 79 - 1

Related factory information

Factory part number: 322376. Applies to tilt-tube steering installations.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Boat Steering Cable Grease, Helm Support Tube & Stainless Hardware

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 322376

Search for original or compatible replacement part 322376. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.