Back to previous page

SB-1497 - Shimming Pinion Gear

Issued June 1979 for Johnson 55 H.P. standard and long models. This factory bulletin explains the revised pinion gear shim specification, replacement driveshaft part numbers, and the gearcase identification stamp.

Johnson Service Bulletin factory letterhead
SB-1497

June, 1979

SUBJECT: SHIMMING PINION GEAR

MODELS: 1979 55 H.P. STANDARD & LONG

Premature pinion gear failure has been reported that upon investigation resulted from over-shimming the pinion gear. A change in shimming specifications on 1979 gearcases has been developed to eliminate this problem and two new service driveshaft assemblies have been released to accommodate this procedure.

The 1979 Preliminary Edition Parts Catalog has listed P/N 389757 Driveshaft for Standard Models and P/N 389758 Driveshaft for Long Models. These driveshafts have been superseded by Driveshaft P/N 391161 - Standard and Driveshaft P/N 391162 - Long.

When shimming the pinion gear on any driveshafts for 1979 and later models using Shim Gauge P/N 320739, follow the service procedure as outlined in your Service Manual and subtract .007” shims from the total shims called for and reassemble minus .007 shims. See Figure 1.

Gearcases that have been corrected at the factory to the minus .007” shims on pinion gear are identified by a stamped number “7” on the rear of the gearcase as shown in Figure 2.

Any gearcases which require a new driveshaft, pinion gear forward gear should be shimmed to this minus .007” shims and stamped with a Number 7, as shown in Figure 2. Existing gearcases that do not require new gears or driveshaft should not be disassembled for the removal of .007” shims.

If you have driveshafts P/N 389757 or P/N 389758 and you can not remove the .007 shims as described, return these to your Distributor for credit and order P/N 391161 or P/N 391162 for use on 1979 and later gearcases.

Figure 1: shim gauge 320739, subtract 0.007 inch from shim thicknessFigure 2: stamp number 7 on rear of gearcase
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 389757

Search for original or compatible replacement part 389757. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.