SB-1498 - Integral TNT Replacement Relief Valve O-Ring
Issued in June 1979, this Johnson Service Bulletin recommends an improved relief valve O-ring for Trim & Tilt units that are inoperative, slow, or unable to trim fully upward.

SB-1498
June, 1979
SUBJECT: INTEGRAL TNT REPLACEMENT RELIEF VALVE O-RING
In the event of either an inoperative Trim & Tilt unit or one that trims up slow or only trims up part way, check for a worn or frayed relief valve o-ring. (See Figure 1.) This O-ring has been superseded by a new one (P/N 326425) which is more resistant to wear. We recommend that this o-ring be replaced as a preventative measure when servicing these trim units.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator
D.J. Leinonen
Technical Data Coordinator
Note: Post on 70 thru V-6 indexes under heading “Lower Unit.”
CR 79-37
© OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED