Johnson Service Bulletin SB-1507 - Cylinder Water Passage Blockages
Issued November 1979, this bulletin identifies 1979 Johnson and Evinrude 4 H.P. outboards requiring inspection for machining chips in the cylinder cooling passages, and provides the factory cleaning procedure.
SB-1507
November, 1979
SUBJECT: OVERHEATING DUE TO BLOCKAGES OF CYLINDER WATER PASSAGES
MODELS: 1979 4 H.P.
Field incidents reported to us indicate there are some 4 H.P. engines that may overheat due to machining chips in the cylinder water passages causing inadequate water flow.
Engines not yet sold and those already sold to customers should be inspected to determine if there are machining chips present in the cylinder water passage which could cause blockage of the water flow and overheat the engine.
Engines where this situation may exist which should be inspected include the following engines:
Use the following procedure to inspect and clean the cylinder water passages and file a standard warranty claim form for 1/2 hour (.5) labor and gasket, P/N 323445.
1. Remove choke knob screw and choke knob.
2. Remove low speed idle knob.
3. Loosen front and rear motor cover screws and remove lower motor cover.
4. Remove ignition leads from spark plugs.
5. Open “J” clamp and lift plug-in connector from ignition coil away from exhaust cover.
6. Remove the nine exhaust cover screws using a 5/16” socket.
7. Remove exhaust cover and gasket from cylinder. Discard gasket.
8. Inspect and clean the water passage, especially in the center “pocket” and top water passage hole as shown in Figure 1.
9. Using a new gasket, P/N 323445, coated with OMC Gasket Sealing Compound, or equivalent, on both sides, reinstall the exhaust cover.
Apply OMC Gasket Sealing Compound to the threads of the nine exhaust cover screws and torque to 25 to 35 in. lbs. (2.8 to 4 N·m).
10. Reassemble engine in reverse order of disassembly and test engine to determine adequate water flow is present as indicated by mist coming from exhaust relief at rear of exhaust tube of gearcase.
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
NOTE: Post on the 4 hp Index under heading “Powerhead”.