Johnson Service Bulletin SB-1511 - Trailing Lock Spring for Accessory Power Tilt Kit
Issued December 1979, this bulletin details the addition of a trailing lock spring to accessory power tilt kit 173669 on 1980 Johnson and Evinrude 70 H.P. through V-4 outboards, including an important trailering safety warning.

SB-1511
December, 1979
SUBJECT: ADDING TRAILING LOCK SPRING, P/N 323142
TO ACCESSORY POWER TILT KIT, P/N 173669
MODELS: 1980 JOHNSON AND EVINRUDE 70 THROUGH V-4
When installing this kit on 1980 Johnson and Evinrude 70 through V-4 manual tilt engines, a new trailing lock spring, P/N 323142, must be installed from locking lever rod through opening in swivel bracket and attach to reverse lock retainer on port side of swivel bracket. See Figure 1.
Step 10 on Page 3 of Installation Instructions should be disregarded for these models and the spring retainer and trail lock spring should be removed, as well as the manual tilt handle. See Figure 1.
The Trail Lock must be operated by hand by moving Trail Lock lever to either trailing position or operating position.
If Power Tilt Kit P/N 173669 has previously been installed on a 1980 Johnson or Evinrude 70 through V-4, install Trail Lock Spring P/N 323142 as described above.
□ NOTE
DISREGARDING THE INSTRUCTIONS ABOVE
MAY RESULT IN DAMAGE TO ENGINE WHEN
IN TRAILERING POSITION.

NOTE: Post on miscellaneous index under heading “Accessories”.
CR 79-77
JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator