SB-1513 - Shift Shaft Sticking and Carburetor Jet Change

Issued January 1980, this Johnson Service Bulletin describes a lubrication modification for sticking shift shafts on 25 and 35 H.P. outboards, followed by revised carburetor jetting for 1979 55 H.P. electric-start models.

Johnson Service Bulletin header
SB #1513
January, 1980
SUBJECT: SHIFT SHAFT STICKING
MODELS: 25 - 1976 THROUGH 1979 35 - 1977 THROUGH 1979
Some instances have been reported where the shifting may be difficult on some 25 and 35 Johnson® outboards, especially when operating in salt water. The grease fitting on the shift shaft does not provide enough grease all the way around the shaft, due to being air bound.
A quick fix to those engines where this problem has been reported, or when salt water use is expected, is to drill a 3/32” (2.4mm) hole in the underneath side of the shift shaft boss to provide relief for the grease to be completely distributed around the shaft. See Figure 1.
This can be done without any disassembly. Apply grease to drill bit to hold chips, and drill carefully through the aluminum until the bit touches the steel shaft. Apply OMC Triple-Guard Grease or OMC Anti-Corrosion Lube or an equivalent through the grease fitting until the grease comes out this hole. Refer to Figure 1 for dimensions and location for the drilled hole.
Figure 1: drilling 3/32 inch hole, 1-1/4 inch dimension
CR 79-64 © OUTBOARD MARINE CORPORATION 1979 ALL RIGHTS RESERVED
(OVER)
Subject: Carburetor Jet Change
Model: 1979 55 Electric
There has been a change in carburetor calibration on 1979 Johnson® and Evinrude® 55 electric models to improve idle and/or acceleration. The upper and lower carburetor idle orifices changed to .048 diameter (Part Number 326500). The lower carburetor intermediate orifice changes to .037 diameter (Part Number 324698).
Some late production motors were built with this improved jetting. These carburetors have either a dot of white paint or the stamped number 48 on the carburetor body.
CR 79-61 © OUTBOARD MARINE CORPORATION 1980 ALL RIGHTS RESERVED
NOTE 1: Post on 25 & 35 h.p. Index under heading “Lower Unit”. NOTE 2: Post on 55 h.p. Index under heading “Carburetion”.
JOHNSON OUTBOARDS D. J. Leinonen Technical Data Coordinator