Back to previous page

SB-1514 - Driveshaft to Crankshaft Spline Wear

Issued March 1980, this Johnson Service Bulletin describes how to reduce spline wear and corrosion on 2 and 4 H.P. outboards by lubricating the upper driveshaft splines and improving the O-ring seal.

Johnson Service Bulletin factory letterhead
SB-1514

March, 1980

Subject: Driveshaft To Crankshaft Spline Wear

Models: All 2 & 4 HP Outboards

Upper driveshaft to crankshaft spline wear on 2 & 4 HP models can be reduced by generous application of OMC Moly Lube (P/N 173250) to the splines. RTV (P/N 263753) may be added to the area around O'ring to improve seal and reduce corrosion of these parts. OMC Moly Lube is also being used on the timer base pilot on 2 & 4 HP outboards to reduce wear.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Bearing Race & Seal Driver Set + Marine Assembly Grease

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 173250

Search for original or compatible replacement part 173250. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.