Back to previous page

SB-1518 - Premature Pinion Bearing Failure

Issued March 1980, this Johnson service bulletin explains the correct orientation of the pinion bearing cage on Johnson and Evinrude V6 outboards. It also specifies OMC Screw Lock 384848 for the retaining setscrew.

Johnson Service Bulletin letterhead
SB-1518

March, 1980

Subject: Premature Pinion Bearing Failure

Models: All Johnson and Evinrude V-6 Models

Early pinion bearing failure has been reported which has been traced to improper installation of the pinion bearing.

The design of this bearing requires this bearing to be installed with the lettered side of bearing toward the powerhead or up. When installed backward, this can result in an early failure.

See marking on Bearing Cage. See Figure 1.

Figure 1: Pinion bearing cage showing letters and markings

Follow the service procedure as shown in your Service Manual for removal and installation of the pinion bearing.

When placing pinion bearing on installation tool, position bearing so when installed in gearcase lettering side of bearing cage will face powerhead.

After installation of new pinion bearing in gearcase, be sure to apply OMC Screw Lock (P/N 384848) to setscrew and turn in until flush or tight with casting. This holds bearing in correct position as installed and helps seal the threaded hole from possible leaks.

JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator