Back to previous page

SB-1526 - Handle Cover Kit, P/N 173742

Issued April 1980, this Johnson Service Bulletin identifies trim-switch wire abrasion in selected OMC remote controls and provides replacement handle-cover identification and warranty instructions.

Johnson Service Bulletin letterhead
SB-1526
April, 1980
Subject: Handle Cover Kit, P/N 173742
Models: OMC Parts and Accessories Surface Mount Remote Control with Trim Switch
OMC Parts and Accessories Single Binnacle Mount Remote Control with Trim Switch
OMC has discovered, under certain situations, the trim switch wires in the OMC Parts and Accessories Surface Mount Remote Control with Trim Switch and OMC Parts and Accessories Single Binnacle Remote Control with Trim Switch may become abraded from rubbing on the handle casting.
The handle covers on the following remote controls should be replaced. See Figures 1 thru 4.
Figure 1: 1978 and 1979 surface mount remote control, parts 173361 and 173575Figure 2: 1980 surface mount remote control, part 173642Figure 3: 1978 and 1979 single binnacle mount remote control, parts 173365 and 173579Figure 4: 1980 single binnacle mount remote control, part 173646
CR 79-83   © OUTBOARD MARINE CORPORATION 1980 ALL RIGHTS RESERVED
Order Handle Cover Kit, P/N 173742, from your Parts Distributor, for all Outboard Remote Controls affected.
The new handle cover can be identified by a smooth area on the outside and the build-up area on the inside with Part Number 123610 molded in the new cover. See Figure 5.
Figure 5: Old cover 123291 and new cover 123610, showing smooth spot and build-up area
As an aid to you in fulfilling your responsibility to your customers and as an incentive to inspect all units that come into your dealership, OMC will issue a credit voucher plus 10% handling for the cover kit plus allow $5.00 for labor.
Please fill out an Evinrude, Johnson, or OMC Parts & Accessories warranty claim form for each unit reworked and submit to:
OMC Parts & Accessories
ATTENTION: SERVICE DEPARTMENT
3225 Prairie Drive - R.R. #5
Beloit, Wisconsin 53511
All claims must include model and serial number of the engine, and the owner's name, address and signature.
NOTE: Post on miscellaneous index under heading “Accessories.”
JOHNSON OUTBOARDS
D.J. Leinonen
Technical Data Coordinator

Remote control part numbers

1978-1979 surface mount: 173361, 173575. 1980 surface mount: 173642. 1978-1979 single binnacle: 173365, 173579. 1980 single binnacle: 173646.

Handle cover kit: 173742. Original cover: 123291. Replacement cover: 123610.