Johnson Service Promotion Bulletin SPB-431 - Back-In Test Tank

Issued in February 1970, this Johnson Motors publication describes a back-in test tank for testing complete boat and outboard motor combinations. The original construction drawing appears on the second page.

Johnson Motors Service Promotion factory letterhead

February, 1970

SUBJECT:  BACK-IN TEST TANK

We have had many inquiries concerning the availability of plans for construction of a back-in type test tank for the purpose of testing complete boat and motor combinations.

On the back side of this bulletin, there are plans for the construction of such a test tank, as described above.  These plans specify 1/4" steel plate as the construction material.  Naturally, it is not necessary to adhere strictly to plan in this area as this type of test tank may be constructed of many other materials, such as, cement block, formed and poured concrete or even wood.

Provisions for draining the tank and an overflow stand pipe for the purpose of scimming the tank are not shown on the plan.  This would be governed by local conditions.

Advantages of such a test tank are in the ability to check out the complete motor and control system consisting of all electrical components, throttle and gear shift controls and other related equipment.

There are some disadvantages to this type of test tank; however, they are few.  For instance, the engine is placed at an angle out of the ordinary running position, and in most cases, it is necessary to submerge the trailer wheels which is not a good practice.

These plans are taken from a dealer's test tank that is used extensively with very satisfactory results.  Be sure and check local ordinances and building codes before constructing your test tank.

JOHNSON MOTORS

J. R. Penland
Service Promotion Manager

JRP:rm

Original back-in test tank construction drawing showing plan, elevations, dimensions and construction notes

Historical notes

The second page is retained as the original factory engineering illustration to preserve its handwritten dimensions and construction details. The factory cautioned readers to check local ordinances and building codes before constructing the tank. This historical document is not a current engineering certification or construction approval.

1970-1980 Johnson Service Bulletin Index