OMC Service Bulletin No. 2014 Rev. 1: Lean at Idle

Issued January, 1981, this fuel system bulletin addresses lean at idle for CS - 55R and 60.

OMC Outboard Service Bulletin
Fuel System

No. 2014 Rev. 1
January, 1981

Subject:   Lean at Idle

Models:   CS - 55R and 60

There have been reports of 1980 55R and 60 model engines exhibiting a lean idle. This condition can be defined as intermittent light backfiring at idle speed.

EvinrudeJohnson
E55RLCSA
E55RSCSA
E60ECSR
E60ELCSR
J55RLCSA
J55RSCSA
J60ECSR
J60ELCSR

The lean condition may be caused for the following reasons:

  1. Improper carburetor linkage synchronization and spark/throttle cam pick-up. (Note: These engines are extremely sensitive to proper linkage synchronization.)
  2. A running change was instituted to increase the idle orifice size from .045 (P/N 323151) to .046 (P/N 327342) to richen the idle mixture. To distinguish between which carburetors have the .046 orifice, the letter “E” appears after the carburetor part number.
  3. Inner exhaust housing to outer exhaust housing seal (P/N 315955) leaking, resulting in no “wall of water” in the exhaust housing. Condition can be visually diagnosed by no water flowing from the rear exhaust relief holes at idle speed.

Install the .046 (P/N 327342) orifice and mark an “E” after the part number on all carburetors with the .045 orifice.

.045 Idle Orifice.046 Idle Orifice
1980 60 modelsCarb Assembly - Lower P/N 391787
Carb Assembly - Upper P/N 391786
391787-E
391786-E
1980 55 Rope modelCarb Assembly - Upper P/N 390929
Carb Assembly - Lower P/N 390930
390929-E
390930-E

Related marine products

eBay: OMC / Evinrude part 323151

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

Idle orifice P/N 327342 - recommendations coming soon.