OMC Bulletin 2018 - Thru-Hub Propeller Difficult to Install

March 1981 factory procedure for installing thru-hub exhaust propellers on OMC outboards.

OMC Outboard Service Bulletin
Subject:Thru-Hub Propeller Difficult to Install–Correct Assembly Procedure
Models:All With Thru-Hub Exhaust

There are some cases where the positioning of the propeller hub in the propeller makes installation of the propeller on the thrust bushing difficult. Place the thrust bushing in the propeller first. The propeller can be “worked” onto the shaft with little difficulty. If necessary, the propeller nut can be run down on the exposed thread and the propeller can be “wrenched” into position. The propeller shaft should turn freely.

The propeller may contact the gearcase housing and drag slightly. Our tests have indicated that after a short period of operation the propeller and hub will align properly and future removal and installation can be done with no difficulty.

Factory illustration of propeller, thrust bushing, spacer, propeller nut and cotter pin