Historical OMC service bulletin No. 2027: Erratic 5 Pulse Tachometer Operation.
OMC Outboard Service Bulletin
Electrical System
No. 2027
September, 1981

Subject: Erratic 5 Pulse Tachometer Operation

Models: 9.9 thru Two Cylinder 60 Electric Start and 4.5 thru 35 Rope Start with Accessory Alternator Battery Charging Kit

A recent change in flywheel magnets on some engines that can use the 5 pulse tachometer has caused erratic operation of the tachometer. The tachometer shows accurate readings at 4000 to 5000 R.P.M., then as engine speed increases, the needle drops suddenly and begins wandering.

If this problem occurs, change the location of the grey tachometer lead on the engine terminal strip. Move the grey lead from connection with the yellow/grey stator and rectifier leads to the yellow/blue leads terminal. See Figures below.

Standard wiring diagramRevised wiring diagram

Note

If a 6 pulse tachometer is used on the engines mentioned above, the tachometer will indicate incorrect R.P.M. This incorrect R.P.M. could cause the selection of the wrong propeller for the engine. The result would be over-speeding of the engine.

CR 81-37

Related marine products

Amazon: Marine tachometers

Related marine supplies

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.