
Subject: Gearcase Speedometer Hose Nipple Replacement and Speedometer Hose Routing
Models: CN V-4 and V-6
The CN V-4 and V-6 model outboard gearcases are equipped with a speedometer pick-up (pitot). Included in the pick-up is a plastic nipple located on the upper forward part of the gearcase. If a speedometer is installed in the boat, the speedometer hose is attached to the nipple.
New engines are shipped with a rubber cap covering the nipple. This cap should only be removed when a speedometer hose is to be attached to the nipple. To avoid breaking the nipple, carefully slit the cap with a knife to ease removal.
If the nipple is broken off, the portion left in the gearcase can be removed by using a screw extractor. A new nipple P/N 326266 can be pressed into the gearcase.
Route the speedometer hose through the steering arm assembly tube of the engine.
To Install the hose:
1. Remove the two anode mounting screws and remove the anode (A) from the exhaust housing. See 1.
2. Remove the rubber cap from the gearcase nipple (B). Carefully slit the cap to ease removal. See 1.
3. Lubricate the hose end with oil or light grease.
4. The hose may be inserted into the steering arm assembly tube from either the top or the bottom. To insert the hose from the bottom:
a. Pass the hose end through the separation between the lower mount bracket (C) and the exhaust housing (D). See 2.


b. Align the end of the hose with the steering arm assembly tube and push the hose up the tube.
c. Using needle nose pliers, grasp the end of the hose at the top of the tube. Pass the hose through the tube until about 3 dm (one foot) remains at the bottom. See 3.
d. Attach the bottom end of the hose to the gearcase nipple.
e. Install the anode and screws. Tighten the screws to a torque of 7-9 N·m (60-80 in. lbs.).
f. Continue passing the hose through the tube until the remaining slack is taken up. Do not pull the hose tight. Rapid hose wear may occur if the hose is held against sharp edges of the lower mount bracket. See 4.
5. To insert the hose from the top:
a. Raise the shift rod seal (E) at the upper end of the steering arm assembly tube with a screwdriver or piece of wire.
b. Pass the hose under the seal and into the tube. See 5.
c. When the hose reaches the bottom of the tube, use a screwdriver or wire to direct the hose end through the space between the exhaust housing and the lower mount bracket.
d. Attach the hose to the gearcase nipple.
e. Install the anode on the exhaust housing. Tighten the screws to a torque of 7-9 N·m (60-80 in. lbs.).
f. Remove the slack from the hose by pulling it back up the tube. Do not pull the hose tight. Chafing of the hose will occur rapidly if the hose is held against sharp edges of the lower mount bracket.
6. Route the upper end of the hose into the boat. Allow slack for engine steering and tilting movement when clamping the hose to the inside of the boat transom.



Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Search for original or compatible replacement part 326266
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.