
The crankcase recirculating check valves can become blocked by crankcase filler block adhesive. Small pieces of the adhesive can break loose while the motor is running. They are carried by oil and gas flow in the crankcase to the filter screen on the valves.
Plugged valves can cause stalling or rough idling when the motor is tilted down after running in a slightly tilted position. Another symptom can be roughness on acceleration after the motor has been idling.
Two types of recirculating check valves have been used on these models. One type of valve is brass, the other is plastic.
The brass valve is affected by the particles of adhesive because it has a smaller filter screen. The plastic valve has a larger screen area and is not affected.
If check valve blockage is suspected, check the recirculating system as follows:
- Tilt the motor to full trim out position.
- While the motor is idling, remove one recirculating hose from the bypass cover nipple. Fuel should pulse from the hose.
- Replace the hose on the nipple and remove and check the fuel flow from each of the remaining hoses one at a time. Replace each hose before removing and checking the next hose.
- If no fuel pulses from the hose, stop the motor and remove the hose from the check valve. Inspect the hose for blockage.
- If the hose is clear, remove the recirculation check valve from the intake manifold. Inspect the filter screen of the check valve. Clean the screen by scraping the adhesive off and then lightly blowing through it with shop air.
- The Service Manual testing procedure for the check valves is included with the V-4 and V-6 intake manifold removal and inspection.
- Install the check valves and tighten to a torque of 8,5 - 9,5 N·m (75 - 85 in. lbs.) on brass valves or 2,3 - 2,8 N·m (20 - 25 in. lbs.) on plastic valves.