November 1982 OMC fuel system bulletin describing a carburetor idle pick-up tube inspection for CN and CT 70 and 75 models.

OMC Outboard Service Bulletin
Fuel System

No. 2058
November, 1982

Subject:   Hesitation on Acceleration

Models:   CN, CT 70 and 75

Hesitation while accelerating with 70 and 75 models could be the result of a number of causes.

One of the causes could be an incorrectly positioned hole in the idle pick-up tube.

If the fuel system - - particularly carburetion - - has been inspected and no cause of hesitation found, check the small hole in the pickup tube.

To check the position of the hole Ⓐ, remove the carburetor from the manifold, hold the throttle valve wide open and inspect the tube from the mounting flange end. See 2.

If the hole Ⓐ is facing a direction that is more than 30° to either side of the carburetor bore centerline Ⓑ, the carburetor must be replaced. See 1 and 2. The tube cannot be repositioned because it is pressed into place and sealed.

This condition could also exist on 1979 and CS 70 and 75 models if a carburetor has been replaced recently with a new service replacement.

Complete a warranty claim form for carburetor replacement and submit the claim to the OMC Warranty Department.

Figure 1: carburetor bore and 30 degree pick-up tube alignmentFigure 2: carburetor idle pick-up tube hole A
CR 82-42

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.