OMC Service Bulletin No. 2072, published March 1983, addresses hesitation on acceleration. The original factory instructions and illustrations are reproduced below.
OMC Outboard Service Bulletin
Fuel SystemNo. 2072March 1983

Subject: Hesitation on Acceleration

Models: CT 75 Outboards

Symptom: Engine hesitates or stalls on acceleration. Primarily a problem when towing water skiers.

Cause: Carburetor calibration leaner than necessary in intermediate range (1000 to 2000 rpm).

Solution: Inspect the fuel system and check spark/throttle adjustments for cause of hesitation. Make sure spark pickup timing is correct. Timing must be TDC ± 1°.

The following recommendation does not apply to P/N 393196 and 393197 carburetors with the letter “C” after the part number. These carburetors already have this improvement.

Intermediate fuel flow is now controlled by the emulsion tube I.D. and the air bleed hole in the tube. Idle and intermediate fuel flow will be increased only slightly and high speed fuel flow is not affected.

If engine continues to hesitate on acceleration refer to Fuel System Service Bulletin No. 2058 for additional information.

⚠ Safety Related

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Inductive Ignition Timing Light

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 393196

Search for original or compatible replacement part 393196

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.