OMC Bulletin 2080: Erratic Tachometer Operation

Troubleshooting tachometer wiring and electrical connections. September 1983.

OMC Outboard Service Bulletin
Accessories
No. 2080
September 1983

Erratic Tachometer Operation

Models: 5-pulse and 5- or 6-pulse OMC tachometers

Subject: Erratic Tachometer Operation

Models: 5 Pulse and 5 or 6 Pulse OMC Tachometers

Tachometers — 5 Pulse Tachometers P/N 173492 and 173493 for the following models:

e 6 thru 35 Models 1977 thru 1982 e 50 thru 60 Models 1978 thru 1982

[Note] These tachometers must not be used on 1983 Models.

Nj Ee]

CESS)

Symptom — Tachometer may show an accurate reading up to 4000 to 5000 RPM then as RPM increases the tach- ometer needle drops suddenly and begins wandering.

Solution — Change the gray tachometer lead (@) on the engine terminal strip from the yellow/gray lead terminal to the yellow/blue lead terminal ©.

Tachometers —5 or 6 Pulse OMC Plug-In Tachometers P/N 174051, 174052, 174053 and 174054.

Symptom — Tachometer may show an accurate reading up to 4000 to 5000 RPM then as RPM increases the tach- ometer needle drops suddenly and begins wandering.

Solution — Change the gray tachometer lead (@) on the

engine terminal strip from the yellow/gray lead terminal to the yellow/blue lead terminal ©).

(Continued)

Accessories

No. 2080 September, 1983

[4] CO 2277

[2] CO 2278

Original numbered factory figures for page 1
Accessories
No. 2080
September 1983

Erratic Tachometer Operation

Models: 5-pulse and 5- or 6-pulse OMC tachometers

These tachometers are designed for 5 or 6 pulse applica- tions. It is important that the adjusting arrow @) on the back of the tachometer is aligned with the correct number to obtain accurate RPM readings.

5 Pulse Operation 6 thru 35 Models (No. 5 Position) 1977 and later

50 thru 60 Models 1978 and later

6 Pulse Operation 75 Models thru V-6's (No. 6 Position) 1968 and later

All OMC Sea Drives

Symptom — Erratic tachometer operation at various engine

speeds. Cause — Inadequate electrical connections at engine or control box.

Solution — Check electrical connections using the following procedure:

Disconnect tachometer plug-in lead at control box.

Make sure pins and sockets are clean and positioned properly in tachometer plug and receptacle ©).

Apply a thin coat of OMC Triple-Guard Grease to the plug @).

Align arrows (©) on plug and receptacle ©) and push together securely.

Test tachometer to see if condition still exists.

If problem still persists check wiring and terminal connections for loose or broken connections.

CO 3346

Original numbered factory figures for page 2

Related marine products

Amazon: Marine tachometers

Related marine supplies

eBay: OMC / Evinrude part 173492

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.